Free STL file MMCX Connector Mod for Koss Porta Pro headphones 🎧・Design to download and 3D print・Cults
Por un escritor de hombre misterioso
Descripción
(New version, which uses a nut to retain the MMCX connector, has been added)
Removeable cables makes everything classier, especially the now ubiquitous Koss Porta Pros.
This model is a holder for an MMCX connector.
The connector can be found on and should be the shorter (8.5mm overall length) M3 threaded version. The holder will need the mounting hole drilled and tapped out to M3. The two screws used are M2x6mm button heads. They screw straight into the pre-existing holes on the driver back and don't require the holes to be drilled or tapped.
The inner pin should be wired to the driver where the red or green signal wire was soldered and the outer tap should connect to the gold ground wires position.
The cable I used is a generic MMCX one for the Shure SE425s as well as many others, from . I had to cut off the stiff shaped sheathing on the wires at the MMCX connector ends.
mmcx 3D Models to Print - yeggi
Voarmaks DIY Modification MMCX Sockets Cover Parts Compatible with Koss Porta Pro Portapro Headphone Ear Pads Foam Cushion : Electronics
[KSC75 Froggie Mod is a removable cable mod for KSC75. This model is for MMCX connectors.], (NOW with added EZ Print STL to print as one part),
KSC75 Froggie Mod MMCX
koss 3D Models to Print - yeggi
▷ koss portapro repair 3d models 【 STLFinder 】
Voarmaks DIY Modification MMCX Sockets Cover Parts Compatible with Koss Porta Pro Portapro Headphone Ear Pads Foam Cushion : Electronics
Ultimate Guide] Koss Modification – Ear Pads, MMCX Sockets, and Detachable Cables, Oh My!
koss 3D Models to Print - yeggi
▷ koss porta pro model 3d models 【 STLFinder 】
koss porta pro mmcx 3D Models to Print - yeggi
de
por adulto (el precio varía según el tamaño del grupo)